Kidde HD135 Manual do Utilizador

AC Wire-in Single and/or Multiple Station (up to 24 Devices) Heat Alarmwith 9 Volt Battery Back Up, 135ºF fixed temperature.Thank you for purchasing t

6. FALSE ALARMSTo avoid false alarms,DO NOT USE WHERE ROOM TEMPERATURES WILL EXCEED100º F.Heat alarms respond only to heat. They do not detect smoke.

This smoke alarm uses a 9V carbon backup battery (alkaline and lithium batteriesmay also be used). A fresh battery should last for one year under norm

8. LIMITATIONS OF HEAT ALARMSWARNING: PLEASE READ CAREFULLY AND THOROUGHLY• HEAT ALARMS ARE NOT DESIGNED TO PROTECT LIFE SAFETY AGAINSTFIRE AND SMOKE

9. GOOD SAFETY HABITSDEVELOP AND PRACTICE A PLAN OF ESCAPE• Install and maintain Fire extinguishers on every level of the home and in thekitchen, base

• Call the fire department from your neighbor’s home - not from yours!• Don’t return to your home until the fire officials say that it is all right to

11. CAUTION (AS REQUIRED BY THE CALIFORNIA STATE FIREMARSHAL)“Early warning fire detection is best achieved by the installation of fire detectionequip

FIVE YEAR LIMITED WARRANTYKIDDE Safety warrants to the original purchaser that the enclosed heat alarm (but notthe battery) will be free from defects

WARNING! BATTERY DOOR WILL NOT CLOSE UNLESS A BATTERY IS PRES-ENT. REMOVAL OF THE HEAT ALARM BATTERY AND DISCONNECTING ORLOSS OF AC POWER WILL RENDER

Note A: Maximum coverage established by U.L. is based on providing equalresponse time as sprinkler devices spaced at 10-Ft intervals (100 Sq/Ft) on a

of alarms shall be spaced and locatedwithin 3 ft (0.9m) of the peak of theceiling measured horizontally” (seefigure 3).• In rooms with open joists orb

• In an area where the temperature may fall below -20ºF or rise above 100ºF.• Near fluorescent lights – electronic "noise" may cause nuisanc

• When mixing models which have battery backup (1275, 1276, 1285, 1296,i12040, i12040A, i12060, i12060A, i12080, i12080A, i4618, i4618A, PE120,P12040

MOUNTING INSTRUCTIONSCAUTION: THIS UNIT IS SEALED. THE COVER IS NOT REMOVABLE!1.Remove the trim ring from the back of the alarm by holding the trim r

7.Install the alarm on the trim ring with the indicating marks aligned and rotatethe alarm in the direction of the “ON” arrow on the cover until the a

5. OPERATION AND TESTINGOPERATION: The heat alarm is operating once AC power is applied, fresh batter-ies are installed and testing is complete. When